Category Timing Belt and oil seals

There are some rubber products that you can’t live without. One of them is the timing belt. The timing belt was introduced in the 1960s. It is made of rubber and has hard teeth. It is present in the internal combustion engine of vehicles and it is an important part for an engine to run. Its function is to synchronize the rotation of the crankshaft and camshaft to enable the pistons and valves of vehicles operate properly. This will help in making the vehicle run smoothly.

Replacing the belt on time is another point you must focus on. After your car or any other automobile runs 60,000-100,000 miles, you should consider getting it replaced. Like custom molded rubber products like gaskets and seals (AS 568 O Rings), a timing belt is also a made from rubber. That is why it will get worn down with time. Upon breaking the engine will not run and your work will come to a standstill. It can result in damage to the different parts of the engine. Not changing the belt on time can cost you a hefty amount later. You may even have to get your vehicle’s engine replaced.

There are several companies that not only manufacture good quality timing belts, but also oil seal, vibration mounts and conveyor belts. One among them is Lusida rubber products.

The timing belt is a rubber product which is an integral part of the internal combustion engine of vehicles. It helps the engine run and you have to get it replaced periodically.

Rubber products are widely used for various applications all over the world. The use of custom molded rubber products is common in the railways, oil and gas industry, automobile industry and many more. They can be Gaskets and Seals, Vibration Mounts, Conveyor Belts and oild seals.  You can find rubber products even in hospitals, canning factories and breweries. In fact, they are a part of our daily life. When they are so important, you should know how they are manufactured.

Here are the common techniques for manufacturing custom molded rubber products are:

1.Compression molding – In this process, uncured rubber is placed in a mold and compressed with pressure and heat to get the final finished rubber component. It gets ejected from the mold and can be used.

2.Injection molding – Here preheated rubber is injected into a mold with the use of pressure to make sure that the rubber gets into every cavity inside the mold. After curing, the product gets separated from the mold and ready to be used.

3.Extrusion – This method is used to make rubber pipes, hoses and tubular products. Here the extruded rubber product is pushed through a die. 

A few other important rubber products that are manufactured using one of the above methods are AS 568 O Rings, Timing Belt and oil seals. 

Rubber products are used in several different applications. They are manufactured using compression molding, injection molding and extrusion.